Super Systems 9010 Series - Manual (Page 8)

SSi Manual Series 9010 – eSPP Programmer Page 8
Chapter 1 - INSTALLATION
Overview
The eSPP/9010 is a programmable instrument that is intended to connect to remote PID controllers via
RS 485. With the use of the 9010 a simple single loop temperature and carbon controller can be used as
a fully programmable control system with ramps, soaks, events and alarms. Additionally the 9010 allows
for zone control for up to five instruments commonly used on continuous furnace applications. The 9010
allows for offsets between zones and includes a digital charting of the process at the touch screen. The
9010 can also serve as a data concentrator for various 485 instrumentation. These instruments can then
be controlled or communicated via Ethernet to a supervisor software package such as SuperData.
The product is available in three different screen sizes. 3.5”, 5.7” and 12”.
Mounting
The Series 9010 Operator Interface mounts into a panel or on a plate by using the enclosed mounting
brackets. A rectangular cutout is required; the size of the cutout is determined by the operator interface
size. These units, along with an optional ADAM module, will mount on a commercially available DIN rail.
This can be mounted on the sub-panel on the side of an enclosure for the convenience of the control
system.