Protocols and standards, Ipv6 basics configuration task list – H3C Technologies H3C S12500 Series Switches User Manual
Page 154
140
semantic translation for packets. This technology is only suitable for communication between a pure IPv4
node and a pure IPv6 node. For more information about NAT-PT, see "Configuring NAT-PT."
NOTE:
The switch does not support NAT-PT.
6PE
6PE is a transition technology by which Internet service providers (ISPs) can use existing IPv4 backbone
networks to allow communications between isolated IPv6 networks.
6PE adds labels to the IPv6 routing information for customer networks and advertises the information into
the IPv4 backbone network over Internal Border Gateway Protocol (IBGP) sessions. IPv6 packets are
labeled and forwarded over tunnels on the backbone network. The tunnels can be GRE tunnels or MPLS
LSPs. For more information about 6PE, see Layer 3—IP Routing Configuration Guide.
Protocols and standards
•
RFC 1881, IPv6 Address Allocation Management
•
RFC 1887, An Architecture for IPv6 Unicast Address Allocation
•
RFC 1981, Path MTU Discovery for IP version 6
•
RFC 2375, IPv6 Multicast Address Assignments
•
RFC 2460, Internet Protocol, Version 6 (IPv6) Specification
•
RFC 2461, Neighbor Discovery for IP Version 6 (IPv6)
•
RFC 2462, IPv6 Stateless Address Autoconfiguration
•
RFC 2463, Internet Control Message Protocol (ICMPv6) for the Internet Protocol Version 6 (IPv6)
Specification
•
RFC 2464, Transmission of IPv6 Packets over Ethernet Networks
•
RFC 2526, Reserved IPv6 Subnet Anycast Addresses
•
RFC 3307, Allocation Guidelines for IPv6 Multicast Addresses
•
RFC 3513, Internet Protocol Version 6 (IPv6) Addressing Architecture
IPv6 basics configuration task list
Task
Remarks
Configuring basic IPv6 functions
Required.
Configuring IPv6 global unicast addresses
Required to
configure one.
Configuring an IPv6 link-local address
Configuring an IPv6 anycast address
Configuring a static neighbor entry
Optional.
Configuring the maximum number of neighbors
dynamically learned
Optional.
Setting the age timer for ND entries in stale state
Optional.