H3C Technologies H3C S12500 Series Switches - Manual (Page 189)

175
Configuration considerations
Configure the DHCPv6 server as follows:
• Enable IPv6 and DHCPv6 server.
• Create a prefix pool containing prefix 2001:0410::/32 with the length of the assigned prefix being
48, so that the server assigns clients the prefixes ranging 2001:0410::/48 to
2001:0410:FFFF::/48.
• Create an address pool. Configure a static prefix in the address pool and have the prefix pool
referenced by the address pool. Configure other configuration parameters.
• Apply the address pool to the interface through which the server is connected to the clients.
• Enable the DHCPv6 server on the interface that connects to the clients and apply the address pool
to the interface.
Figure 71 Network diagram
Configuration procedure
# Enable IPv6 and DHCPv6 server.
<Switch> system-view
[Switch] ipv6
[Switch] ipv6 dhcp server enable
# Configure the IPv6 address of VLAN-interface 2.
[Switch] interface vlan-interface 2
[Switch-Vlan-interface2] ipv6 address 1::1/64
[Switch-Vlan-interface2] quit
# Create and configure prefix pool 1.
[Switch] ipv6 dhcp prefix-pool 1 prefix 2001:0410::/32 assign-len 48
# Create address pool 1.
[Switch] ipv6 dhcp pool 1
# Apply prefix pool 1 to address pool 1, and set the preferred lifetime to one day, the valid lifetime to
three days.
[Switch-dhcp6-pool-1] prefix-pool 1 preferred-lifetime 86400 valid-lifetime 259200
# Configure static prefix 2001:0410:0201::/48 in address pool 1, and set the client DUID as
00030001CA0006A40000, the preferred lifetime to one day, and the valid lifetime to three days.
[Switch-dhcp6-pool-1] static-bind prefix 2001:0410:0201::/48 duid 00030001CA0006A40000
preferred-lifetime 86400 valid-lifetime 259200