H3C Technologies H3C S12500 Series Switches - Manual (Page 173)

159
[SwitchA-Vlan-interface2] quit
# Specify a global unicast address for VLAN-interface 1, and allow it to advertise RA messages (no
interface advertises RA messages by default).
[SwitchA] interface vlan-interface 1
[SwitchA-Vlan-interface1] ipv6 address 2001::1/64
[SwitchA-Vlan-interface1] undo ipv6 nd ra halt
[SwitchA-Vlan-interface1] quit
2. Configure Switch B:
# Enable IPv6.
<SwitchB> system-view
[SwitchB] ipv6
# Configure a global unicast address for VLAN-interface 2.
[SwitchB] interface vlan-interface 2
[SwitchB-Vlan-interface2] ipv6 address 3001::2/64
[SwitchB-Vlan-interface2] quit
# Configure an IPv6 static route with destination IP address 2001::/64 and next hop address
3001::1.
[SwitchB] ipv6 route-static 2001:: 64 3001::1
3. Configure the host:
Enable IPv6 for the host to automatically obtain an IPv6 address through IPv6 ND.
# Use the command ping ipv6 on Switch A to check if the switch B is reachable.
[SwitchA] ping ipv6 3001::1
PING 3001::1 : 56 data bytes, press CTRL_C to break
Reply from 3001::1
bytes=56 Sequence=0 hop limit=64 time = 3 ms
Reply from 3001::1
bytes=56 Sequence=1 hop limit=64 time = 2 ms
Reply from 3001::1
bytes=56 Sequence=2 hop limit=64 time = 2 ms
Reply from 3001::1
bytes=56 Sequence=3 hop limit=64 time = 3 ms
Reply from 3001::1
bytes=56 Sequence=4 hop limit=64 time = 9 ms
--- 3001::1 ping statistics ---
5 packet(s) transmitted
5 packet(s) received
0.00% packet loss
round-trip min/avg/max = 2/3/9 ms
# Display neighbor information on GigabitEthernet 3/0/2 of Switch A.
[SwitchA] display ipv6 neighbors interface gigabitethernet 3/0/2
Type: S-Static D-Dynamic
IPv6 Address Link-layer VID Interface State T Age
FE80::215:E9FF:FEA6:7D14 0015-e9a6-7d14 1 GE3/0/2 STALE D 1238
2001::15B:E0EA:3524:E791 0015-e9a6-7d14 1 GE3/0/2 STALE D 1248