Configuring port security features, Configuring ntk, Configuring intrusion protection – H3C Technologies H3C S12500-X Series Switches User Manual

Page 107

Advertising
background image

95

68B

Configuring port security features

205B

Configuring NTK

The NTK feature checks the destination MAC addresses in outbound frames to make sure frames are

forwarded only to authenticated devices.
The NTK feature supports the following modes:

ntkonly—Forwards only unicast frames with authenticated destination MAC addresses.

ntk-withbroadcasts—Forwards only broadcast frames and unicast frames with authenticated
destination MAC addresses.

ntk-withmulticasts—Forwards only broadcast frames, multicast frames, and unicast frames with
authenticated destination MAC addresses.

With the NTK feature, any unicast frame with an unknown destination MAC address is discarded. Not

all port security modes support triggering the NTK feature. For more information, see

809H

Table 5

.

To configure the NTK feature:

Step Command

Remarks

1.

Enter system view.

system-view

N/A

2.

Enter interface view.

interface interface-type
interface-number

N/A

3.

Configure the NTK feature.

port-security ntk-mode

{ ntk-withbroadcasts |
ntk-withmulticasts | ntkonly }

By default, NTK is disabled on a
port and all frames are allowed to

be sent.

206B

Configuring intrusion protection

Intrusion protection enables a device to take one of the following actions in response to illegal frames:

blockmac—Adds the source MAC addresses of illegal frames to the blocked MAC addresses list
and discards the frames. All subsequent frames sourced from a blocked MAC address are dropped.

A blocked MAC address is restored to normal state after being blocked for 3 minutes. The interval

is fixed and cannot be changed.

disableport—Disables the port until you bring it up manually.

disableport-temporarily—Disables the port for a specific period of time. The period can be
configured with the port-security timer disableport command.

To configure the intrusion protection feature:

Step Command

Remarks

1.

Enter system view.

system-view

N/A

2.

Enter interface view.

interface interface-type
interface-number

N/A

Advertising