Binding a source interface to an ipsec policy – H3C Technologies H3C S12500-X Series Switches User Manual
Page 204
192
Figure 56 Specifying the private key file
g.
Click Open to connect to the server.
If the connection is successfully established, the system asks you to enter the username. After
entering the username (client002), you can enter the CLI of the server.
283B
Password authentication enabled Stelnet client configuration
example
500B
Network requirements
As shown in
900H
Figure 57
, you can log in to Switch B through the Stelnet client that runs on Switch A and are
assigned the user role network-admin for configuration management. Switch B acts as the Stelnet server
and uses password authentication. The username and password of the client are saved on Switch B.
Figure 57 Network diagram
501B
Configuration procedure
1.
Configure the Stelnet server:
# Generate the RSA key pairs.
<SwitchB> system-view