Configuring an ike profile, Configuring the ipv6 source guard function, Enabling ipv6 source guard on an interface – H3C Technologies H3C S12500-X Series Switches User Manual

Page 221

Advertising
background image

209

Step Command

Remarks

3.

Configure a static IPv4

source guard binding
entry.

ip source binding { ip-address
ip-address | ip-address

ip-address mac-address

mac-address | mac-address

mac-address } [ vlan vlan-id ]

By default, no static IPv4 source guard
binding entry is configured on an interface.
The vlan vlan-id option is supported only in
Layer 2 Ethernet interface view.
A VLAN ID is required if the static IPv4
source guard binding entry is used in the

ARP detection function, and the specified
VLAN must be enabled with the ARP

detection function. Otherwise, ARP packets

cannot bypass the check of the static IPv4

source guard binding entry on the interface.
You cannot configure the same static IPv4
source guard binding entry on one

interface, but you can configure the same

static IPv4 source guard binding entry on
different interfaces.

128B

Configuring the IPv6 source guard function

You cannot configure the IPv6 source guard function on a service loopback interface. If IPv6 source

guard is enabled on an interface, you cannot assign the interface to a service loopback group.

292B

Enabling IPv6 source guard on an interface

You must first enable the IPv6 source guard function on an interface, and use static source guard binding
entries to filter packets. For information about how to configure a static IPv6 source guard binding entry,

see "

913H

Configuring a static IPv6 source guard binding entry

."

To enable the IPv6 source guard function on an interface:

Step Command

Remarks

1.

Enter system view.

system-view

N/A

2.

Enter interface view.

interface interface-type
interface-number

The interface-type argument can
be Layer 2 Ethernet interface,

Layer 3 Ethernet interface, and
VLAN interface.

3.

Enable the IPv6 source guard
function.

ipv6 verify source { ip-address |
ip-address mac-address |

mac-address }

By default, the function is disabled
on an interface.
If you configure this command on
an interface multiple times, the

most recent configuration takes
effect.

Advertising