H3C Technologies H3C S12500-X Series Switches User Manual
Page 63
51
c.
Select the service type Device Management Service.
d.
Select the access device type H3C.
e.
Select the access device from the device list or manually add the access device (with the IP
address 10.1.1.2).
f.
Leave the default settings for other parameters and click OK.
The IP address of the access device specified here must be the same as the source IP address of the
RADIUS packets sent from the switch, which is chosen in this order on the switch:
{
IP address specified by the nas-ip command
{
IP address specified by the radius nas-ip command
{
IP address of the outbound interface (the default)
Figure 14 Adding the switch as an access device
# Add an account for device management.
Click the User tab, and select Access User View > Device Mgmt User from the navigation tree. Then,
click Add to configure a device management account as follows:
a.
Enter the account name hello@bbb and specify the password.
b.
Select the service type SSH.
c.
Specify 10.1.1.0 to 10.1.1.255 as the IP address range of the hosts to be managed.
d.
Click OK.
NOTE:
The IP address range must contain the IP address of the switch.