H3C Technologies H3C S12500-X Series Switches - Manual (Page 159)

151
Figure 103 Locating the packed plastic panel
(1) Packing bag (2) Plastic panel packing box
5. Erect one paper angle bead along each vertical edge of the chassis, and use the carton to cover
the chassis from top down with the mark side facing the front panel of the chassis.
6. Cover the foam cushion to the chassis top, and make sure the mounting brackets seat into the
internal notches of the foam cushion. See callout 2 of
Figure 104 .
7. Put the box of packed accessories into the notch of the foam cushion that is near to the rear end of
the chassis, as shown in callout 3 of
Figure 104 .
8. Cover the top cap to the carton.