Figure 53 – H3C Technologies H3C S12500-X Series Switches User Manual
Page 80
Advertising
72
5.
Slowly move the switching fabric module outward. Holding both sides of the switching fabric
module, pull the switching fabric module out of the slot along the slide rails, as shown in
6.
Put the removed switching fabric module on the antistatic mat.
7.
Install a new switching fabric module. For the installation procedures, see "Installing FRUs."
Figure 53 Replacing a switching fabric module (1)
(1) Loosen the captive screw
(2) Move the ejector levers outwards
Advertising