H3C Technologies H3C SR6600 - Manual (Page 146)

136
LED Status Description
(green)
USB port LED
Off No host is connected to the device-mode USB port.
Steady on
A host is connected to the device-mode USB port. The USB
cable can be unplugged in this state.
Flashing
Data is being transmitted or received through the
device-mode USB port. In this state, do not unplug the USB
cable.
(yellow/gree
n)
Management
Ethernet port
LED
Solid yellow A 10/100 Mbps link is present.
Solid green A 1000 Mbps link is present.
Flashing yellow
Data is being received or transmitted at a rate of 10/100
Mbps.
Flashing green
Data is being received or transmitted at a rate of 1000
Mbps.
(green)
Active LED of
the RSE-X1
Off The RSE-X1 is in the standby state.
Steady on The RSE-X1 is in the active state.
(red)
Power
management
alarm LED
Off The system power module is normal.
Steady on The system power is insufficient.
(green)
Run LED
Off No power input is available, or the RSE-X1 has failed.
Slow flashing
(1 Hz)
The RSE-X1 is operating correctly.
Fast flashing (8
Hz)
The application software is being loaded (in this case,
never power off the device or hot-swap the RSE-X1;
otherwise the RSE-X1 might be damaged).
(red)
Alarm LED
Off The system is operating correctly and there is no alarm.
Steady on
A fault has occurred to the system or the available power is
insufficient. In this state, check the system log immediately.
CAUTION:
Do not remove the CF card when the CF LED is flashing. Otherwise, the file system on the CF card will be
damaged.
Figure 120 MCP-X1 LEDs