H3C Technologies H3C SR6600 - Manual (Page 80)

70
Figure 71 Pulling the RSE-X1 MPU out of the slot
4. If you do not install a new MPU in the slot, install a blank panel. To install a new MPU, see
"
Installing an RSE-X1 MPU ."
Replacing an MCP
To replace an MCP, for example, MCP-X1:
1. Determine the MCP to be removed. This section takes the MCP in slot 1 as an example.
2. Use a Phillips screwdriver to loosen the captive screws on the MCP to be removed until all spring
pressure is released.
3. Holding the ejector levers of the MCP with both hands, pull the ejector levers outward, and gently
pull the MCP out of the slot along the slide rails.
Figure 72 Pulling the MCP out of the slot