Installing a him – H3C Technologies H3C SR6600 User Manual
Page 29
19
Figure 16 Inserting a SAP module
4.
Fasten the captive screws on the SAP module with a Phillips screwdriver.
5.
Power on the router.
After the SAP module is powered on, the RUN LED (green) flashes once and then flashes fast (at 8
Hz). It flashes slowly (at 1 Hz) after the application is loaded. This means that the SAP module runs
correctly.
Installing a HIM
Only the FIP-210 support HIMs.
HIMs are hot swappable and you must perform the remove slot number command to stop the module
before you remove it.
To install a HIM:
1.
Locate the slot to install the HIM on the FIP module. A HIM occupies two slots of the FIP module.
2.
Remove the captive screws on the filler panel with a Phillips screwdriver, and then use a flat-blade
screwdriver to prize the filler panel to remove it from the router.
3.
Use even pressure to push the HIM slowly along the slide rails into the slot, and then pull the levers
inward.