Mounting the main docking station – Grass Valley 3-CCD CameraMan Rev.C User Manual
Page 20
Chapter 2
14 CameraMan 3-CCD Presenter Camera System Installation and Operations
Use the following procedure to remove the Camera-
Man Connector Block:
1.
Turn the POWER switch on the back of the Cam-
era OFF.
2.
Disconnect all cables from the back of the cam-
era.
3.
Remove the three screws that hold the connec-
tor block in place.
4.
Pull the connector block out, unplugging it from
the DB-37 connector. The Main Docking Station
cable plugs into this port.
Mounting the Main
Docking Station
FIGURE 2.2
Backpanel with Power Supply
You can mount the Main Docking Station with any
orientation, but you must mount it within 10’ of the
autoTRACK camera (use only the supplied Camera-
Man cable to connect the two units). Mount the Main
Docking Station using the following guidelines:
1.
Mount the Main Docking Station in the desired
location. Be sure to leave enough space for
access to the connections on the back panel.
2.
Verify that the POWER switch is OFF on the
front of the Main Docking Station.
3.
Mount or place the CameraMan Power Supply in
a convenient location near the autoTRACK
Docking station.
4.
Plug the 5.5mm female connector from the
power supply cord into the DC POWER jack in