Grass Valley 3-CCD CameraMan Rev.C - Manual (Page 58)

52 CameraMan 3-CCD Presenter Camera System Installation and Operations Manual
Appendix B
Problem
The Tracking System Keypad will not control the
autoTRACK Camera when used in the wireless
RF mode.
Solution
1. Verify that the batteries are installed in the key-
pad properly.
2. Verify that the BASE UNIT ADDRESS switch on
the back of the autoTRACK Camera, and the
BASE UNIT ADDRESS switch in the battery
compartment of the keypad are set to the same
setting.
3. Verify RF command switch on the back of the
autoTRACK Camera is set to ENABLE (Switch
Bank B-4).
4. Verify that the LED on the front of the Tracking
System Keypad illuminates for a few seconds
when the battery is first installed.
Problem
The Tracking System Keypad will not communi-
cate with the autoTRACK Camera in a “hard-
wired” mode.
Solution
1. Verify that the CameraMan Keypad Cable is
connected from the PVI COM port on the back
of the Main Docking Station to the RJ-11 jack in
the battery compartment of the Tracking System
Keypad.
2. Does the LED on the front of the keypad come
on for a few seconds when the keypad is first
plugged in? If not, replace cable with a Grass
Valley supplied cable only.
Problem
The autoTRACK Camera’s Video is not working
properly.
Solution
1. Verify that the VIDEO SELECT switch on the
back of the autoTRACK Camera is set properly.