Grass Valley 3-CCD CameraMan Rev.C - Manual (Page 44)

Chapter 4
38 CameraMan 3-CCD Presenter Camera System Installation and Operations
3. Use the manual FOCUS buttons to set the focal
point, if needed.
4. Use the manual IMAGE buttons to set the
needed light/dark contrast, if needed.
5. Press and hold LEFT until you hear two beeps,
indicating the new setting is stored.
To RECALL the left autoTRACK VIEW:
Press and release LEFT View. The camera recalls
the information stored in the LEFT button.
Using Subject Position and Pan/Tilt Arrows
This section is dependent upon the orientation of
your panning arrows. We have used the default ori-
entation for the examples.
Subject Position Arrows
In the autoTRACK mode, press any one of the four
directional Subject Position arrows to adjust your
location in the current autoTRACK View. Pressing
the up, down, right or left arrow changes the sub-
ject’s position in the video frame.
If the subject appears too low in the frame...
...press the UP arrow to lower the camera, and raise
the subject’s position.