Grass Valley 3-CCD CameraMan Rev.C - Manual (Page 31)

Configure Your Presenter System
CameraMan 3-CCD Presenter Camera System Installation and Operations Manual 25
FIGURE 3.2 Facing with CameraMan Camera
However, there are applications in which you do not
need to face the camera, so the default setting will
not work. In these cases, you can stand BEHIND the
camera, as shown above. But when you want the
camera to move right, the picture moves left. These
applications require that you re-orient the PAN
arrows. Some examples of applicaions that might
benefit from this re-orientation are:
• Presentations where you are not the presenter,
but are controlling the camera’s movement.
• Videoconferences where you are a moderator,
but not an on-screen participant.
• Applications where you are in a control room
controlling the camera.
• Any other application where the keypad control-
ler does not need to be on camera.
Re-Orienting the Pan
Arrows
To re-orient (reverse) the default setting of the PAN
arrows on your Camera Control Keypad, use the fol-
lowing procedure:
Press and hold the TRACKING FREEZE and
SETUP buttons simultaneously. The keypad will
beep after about two seconds. Release the buttons.
This will also reverse the operation of the SUBJECT
POSITION arrows.