Grass Valley 3-CCD CameraMan Rev.C - Manual (Page 36)

Chapter 4
30 CameraMan 3-CCD Presenter Camera System Installation and Operations
4. Press one of the four autoTRACK View buttons
on the keypad to activate the autoTRACK func-
tionality of the Camera System (the camera will
not track until one of the autoTRACK buttons is
pressed). Once you are in autoTRACK mode,
the autoTRACK LED on the camera’s display
panel will illuminate.
If the autoTRACK LED on the CameraMan’s dis-
play panel is blinking, CameraMan is in autoTRACK
mode, but the link between CameraMan and the
Tracking Ring is not active.
To establish this link, move into the CameraMan’s
field-of-view (see the autoTRACK MODE or Trou-
bleshooting sections of this manual for further assis-
tance).
Rechargeable Battery
The Tracking Ring Power Pack comes with a built-in
12-hour Rechargeable Battery. When the battery is
running low, the Battery LOW LED on the top of the
Tracking Ring Power Pack illuminates. At this time
the Tracking Power Pack should be recharged or an
Auxiliary Battery Pack should be attached to the
Tracking Ring Power Pack.
To recharge the battery:
1. Turn OFF the Tracking Ring Power Pack.
2. Set the switch on the front of the Battery Charger
to TRACKING POWER PACK.
3. Plug the Battery Charger into an electrical outlet
and connect it to the Power Pack.
The Battery Charger takes two to three hours to
recharge the Tracking Ring Power Pack.