Grass Valley 3-CCD CameraMan Rev.C - Manual (Page 48)

Chapter 4
42 CameraMan 3-CCD Presenter Camera System Installation and Operations
The HOME position is also used as a default posi-
tion while in the tracking mode. This means that dur-
ing tracking, if the line-of-sight between the camera
and the Tracking Ring is obstructed, the camera will
automatically return to the HOME position. See
“AutoTRACK Mode” on page 32 and “AutoFIND” on
page 40 for more information.
The Location Preset HOME button is factory set for
the autoTRACK Camera to be facing straight ahead
(in the direction of the “front” label on the bottom of
the camera). This factory setting can be reset by the
presenter to accommodate his or her needs.
Preset 2 and Preset 3
The other two Location Presets can be used to store
key presentation areas such as a map or other
visual aids. These Presets can also be recalled at
any time during a videoconference.
To SET or CHANGE Home, Preset 2, or Preset 3:
1. After selecting a Preset, use the Pan/TILT
arrows to move the camera to the desired loca-
tion.
2. Only when desired, use the manual ZOOM but-
tons to set the needed Zoom perspective.
3. Only when desired, use the manual FOCUS but-
tons to set the focal point.
4. Only when desired, use the manual IMAGE but-
tons to set the needed light/dark contrast.
5. Press and hold any of the three Location Preset
buttons (HOME, PRESET2 or PRESET3) until
you hear two beeps.
To RECALL a Location Preset:
Press and release the desired Location Preset but-
ton (HOME, PRESET2 or PRESET3). The Camera-
Man will then move to the memorized location and
recall the information stored for that Preset.