Grass Valley K2 Storage System Instruction Manual v.3.2 Sep.24 2007 - Manual (Page 283)

September 7, 2007 K2 Storage System Instruction Manual 283
Configuring remaining servers
Network Configuration
This page displays the
control network Ethernet
port, and allows you to
configure the FTP/
Streaming network Ethernet
port.
The top port is the port over which the K2 System Configuration
application is communicating with the K2 Media Server. If correctly
configured, it is already assigned the control network IP address, as
displayed on this page.
Select the other port and click
Modify . A network configuration dialog
box opens. Enter the FTP/Streaming IP address and the subnet mask and
click
Apply .
Click Next .
File System Server
Configuration
This page checks on the
configuration of the K2
Media Server in one of its
main roles as a file system
server. The K2 Media Server
also functions as a file
system client, which is also
checked from this page.
It is not necessary to bind
RANKs or create a file
system, since those tasks
were completed when you
configured the first K2
Media Server.
Click Check . Confirm a “… default.cfg file copied…” message. When
the wizard reports that the configuration check is successful, click Next .
and Yes to confirm copying default.cfg to the server.
If you get a “The V: will not be available until this device is rebooted…”
message, you can safely continue with this procedure and follow the
instructions related to this message later in the procedure.
On this page… Do this…