Grass Valley K2 Storage System Instruction Manual v.3.2 Sep.24 2007 - Manual (Page 340)

340 K2 Storage System Instruction Manual September 7, 2007
Chapter 8 Installing the Level 10R Storage System
5. Set Spanning Tree to On and click Apply Changes . If prompted, log in with the
switch’s administrator username and password.
6. Click Port Configuration .
7. If you do not need trunks, such as on a one-switch system, skip to the next step in
this procedure. If you need trunks, such as on a two-switch system with ISLs, do
the following:
a. Select (Ctrl + Click) the trunked ports. Typically the trunked ports are at the
bottom of the list and are labeled Trk1.
b. Click Modify Selected Ports .
If prompted, log in as administrator.