Grass Valley K2 Storage System Instruction Manual v.3.2 Sep.24 2007 - Manual (Page 322)

322 K2 Storage System Instruction Manual September 7, 2007
Chapter 7 Installing the Level 10 Storage System
2. For the Real Time Input/Output (RTIO) rate, enter the value specified by your
system design. If you do not know this value, contact your Grass Valley
representative.
3. If the K2 Storage System is to be accessed by only K2 Media Clients you can leave
Windows Security unchecked. If accessed by Aurora Edits, refer to the Aurora Edit
Installation and Configuration Guide for instructions.
4. Click OK . The Configuration File dialog box opens.
The configuration file for the media file system is displayed. You can verify media
file system parameters by viewing this file. Do not edit this file. Click
Accept .
A “…Please wait…” message box displays progress and a “…succeeded…”
message confirms the process is complete.
5. A message informs you that you must restart the K2 Media Server, however the
restart at the end of the Configure K2 Server wizard suffices, so you do not need to
restart now.
6. Close the Storage Utility.
NOTE: Do not attempt to start K2 Media Clients or otherwise bring the K2 Storage
System online until instructed to do so later in this chapter.
7. Continue with the next procedure.