Grass Valley Kaleido-Solo Installation v.5.00 - Manual (Page 107)

GUIDE TO INSTALLATION AND OPERATION
Kaleido-Solo | 103
16 Specifications
VIDEO
Signal: SMPTE-259M-C (270 Mbps)
SMPTE-272M-C (270 Mbps with embedded audio)
SMPTE-292M, SMPTE-299M (HD: 1.485, 1.485/1.001 Gbps)
SMPTE-425 (2.970, 2.970/1.001 Gbps)
Supported formats: SD: 480i59.94, 576i50
HD: SMPTE-274M: 1080i 50, 59.94, 1080p/PsF 23.98, 24, 25
HD: SMPTE-296M: 720p 50, 59.94
3G: SMPTE-425 level A (mapping 1): 1080p 50, 59.94
3G: SMPTE-425 level B: 1080p 50, 59.94 (Dual Link)
Cable length: 240 m Belden 1694A at 270 Mbps
150 m Belden 1694A at 1.485 Gbps
120 m Belden 1694A at 2.97 Gbps
Return loss: >15 dB up to 1.5 GHz
>10 dB up to 3 GHz
Jitter: HD/SD: <0.2 UI as per alignment jitter in SMPTE spec.
3Gbps: <0.3 UI as per alignment jitter in SMPTE spec.
FIBER I/O SMPTE 297M-2006 compliant
Single receive or transmit or receive/transmit SFP module

Dual receive or transmit modules can be installed, but only one Rx or Tx
channel will be used
HDMI OUTPUT
Connector: HDMI Type A
Standard: HDMI 1.3a
Format: Compliant to EIA/CEA-861-D
ANALOGIC AUDIO OUTPUT
Connector: 3.5 mm stereo Jack
Signal: 2 channels unbalanced analog audio
Level: 2V peak to peak
Impedance: 10 KOhms
SPDIF
Connector: 3.5 mm stereo Jack
Signal: IEC 60958
Level: 0.5 Vp-p ±20%
Impedance: 75 Ohms unbalanced
Sampling rate: 48 kHz
ETHERNET
Connector: RJ-45
PROCESSING
Signal path: 8 bits
Processing delay: 1 frame
ELECTRICAL
Voltage range: 6 to 17 VDC
Power: 10 W