Grass Valley Kaleido-Solo Installation v.5.00 - Manual (Page 47)

GUIDE TO INSTALLATION AND OPERATION
Kaleido-Solo | 43
1st Loudness/2nd Loudness - Manual Coding Mode
The manual coding mode offers a way to manually configure the loudness measurement. Changing the coding mode
will enable or disable channel assignments. For example if you select 1/0 (c), only the center channel can be
assigned and be considered in the loudness measurement.
Here is a list of available coding modes:
1/0 (C)
1/0 (C) TO STEREO
2/0 (L, R)
3/0 (L, C, R)
3.0L (L, C, R, LFE)
2/1 (L, R, S)
2/1L (L, R, S, LFE)
3/1 (L, C, R, S)
3/1L (L, C, R, S, LFE)
2/2 (L, R, Ls, Rs)
2/2L (L, R, Ls, Rs, LFE)
3/2 (L, C, R, Ls, Rs)
3/2L (L, C, R, Ls, Rs, LFE)
Note that the 1/0(C) TO STEREO selection will copy one channel (selectable) into a stereo pair for proper
loudness measurement.
1st Loudness/2nd Loudness - Target Src (Dialnorm)
Manual By selecting this option you can change the loudness chart target in the loudness advanced
menu (Loud. Adv - see section 5.4.6).
Follow Metada The loudness chart target is defined within the extracted Dolby metadata program.
1st Loudness/2nd Loudness - Input Selection
You can manually assign a physical channel to each available loudness input position, if the program selection is set
to manual and the coding mode permits the position assignment.
A coding mode 2/0 (L, R) will only permit channels to be assigned to the L and R positions.
A coding mode 1/0 (C) will only permit a channel to be assigned to the C position.
Note that you cannot assign the same channel twice.