Grass Valley Kaleido-Solo Installation v.5.00 - Manual (Page 79)

GUIDE TO INSTALLATION AND OPERATION
Kaleido-Solo | 75
5.8 General - Remote
You can assign up to 2 actions to each of the optional remote control buttons #1 to #4 (see section 15). Here are the
possibilities:
No Action: Nothing.
Load User Preset 1 to 5: Load a previously saved associated preset (see section 5.7).
Reset Loudness: Reset loudness measurement (see section 5.4.7).
Pause Loudness: Pause loudness measurement (see section 5.4.7).
Run Loudness: Run loudness measurement (see section 5.4.7).
Toggle Loudness 1 and 2 This is a special action to toggle between loudness mono meter chart #1 and #2 (see
section 5.5.2).
Toggle Loudness Layout Cycles between the full screen loudness layout and last active layout (see section 5.5.2).
Loudness Timecode
SOM Grab the actual time code and place it in the “start of measurement (see section 5.4.8).
Loudness Timecode
EOM Grab the actual time code and place it in the “end of measurement (see section 5.4.8).