Casio XW-G1 - Manual (Page 39)

Selecting and Creating Tones
E-37
* When a tone with DSP (tone that uses a particular DSP) that is not a Solo Synthesizer tone is selected. A tone with DSP will
have “DSP” next to its display name on the mixer screen (page E-78) or performance editing screen (page E-73).
■ Chorus and DSP Use Restrictions
Only one of the three effect types (Chorus, Normal DSP, Solo Synthesizer DSP) can be enabled at any time.
1.
Hold down
bn
EFFECT until the effect list top screen shown below appears.
(1) Reverb Adds reverberation to make it sound like you are playing in a room or in a hall.
(2) Chorus Combines multiple layers of the same note to create a sound with more depth.
(3) Normal DSP A collection of versatile Normal DSP effects help to enhance the sound of tones. For example,
distortion can be applied to an electric guitar sound to make it sound more powerful. There are 46
different Normal DSP types, and the most appropriate one for the selected tone is applied
automatically.
*
A DSP can be edited and saved as a user DSP.
(4) Solo Synthesizer DSP One of the elements that makes up a Solo Synthesizer tones. See “(7) Total Block” in the “Editable
Parameters for Solo Synthesizer Tone” on page E-21. There are six Solo Synthesizer DSP types.
When you edit a Solo Synthesizer DSP, it is saved as part of a Solo Synthesizer user tone. You
cannot save it as a user DSP.
(5) Master Equalizer Adjusts the frequency characteristics of the Synthesizer’s notes. The Master Equalizer can be used
to adjust the frequency and gain of four frequency bands: low, mid1, mid2, and high.
Under this condition: This type of effect is valid:
And effects are applied to each
part like this:
Chorus Mode
• A tone other than the Song Sequencer is selected by
Zone Part 1, and the Chorus is selected by “Chorus/
DSP Select” (page E-38).
(2) Chorus Depends on the mixer chorus send
value (page E-80) and the selected
tone chorus send value (page E-29).
Normal DSP Mode
• A tone other than the Song Sequencer is selected by
Zone Part 1, and the DSP is selected by “Chorus/DSP
Select” (page E-38).
(3) Normal DSP (3) is applied only to parts whose
mixer DSP line (page E-80) is on.
Solo Synthesizer Tone Mode
• Solo Synthesizer tone selected by Zone Part 1.
(4) Solo Synthesizer DSP (4) is applied only to Zone Part 1 and
parts whose mixer DSP line is on.
To configure effect settings
bn