Casio XW-G1 - Manual (Page 43)

Sounding Arpeggios Automatically
E-41
6.
Select arpeggio hold or synchro ON/OFF.
• If you want to turn on the hold function (HOLD), press
bk
STEP +. Each press toggles HOLD between on and
off.
• If you want to turn on the sync function (SYNC), use
bk
STEP – to cycle through the available sync settings
described below.
• The HOLD and SYNC settings are performance
parameters.
7.
Press some keys and the arpeggio will start to
play automatically.
• To turn off the Arpeggio Function, press
bn
ARPEGGIO again.
• To stop arpeggio HOLD playback, press
bn
ARPEGGIO or change the HOLD function in step 2 of
the above procedure to OFF.
■ You can use the arpeggio type selection screen
to select the recommended tone for the currently
selected arpeggio type as your Zone Part 1 tone.
1.
Hold down
bn
ARPEGGIO until the arpeggio
type selection screen appears on the display.
2.
Hold down
7
EDIT until
bn
ARPEGGIO starts
to flash and then stops flashing to remain lit.
• In the case of a user arpeggio, the tone that was
selected as the Zone Part 1 tone when the user data
was saved is the recommended tone.
There are two arpeggio types: step type and variation type.
• With a step type arpeggio, you can edit its steps and its
parameters. A step type arpeggio can contain up to 16
steps. You can change the following values for each step.
• With a variation type arpeggio, you can edit only its
parameters.
1.
Hold down
bn
ARPEGGIO until the arpeggio
type selection screen shown below appears on
the display.
2.
From among the preset or user arpeggio types
select the arpeggio type you want to edit.
• For information about how to select an arpeggio type,
see steps 2 through 5 under “To use the Arpeggio
Function” (page E-40).
3.
Press
7
EDIT.
4.
Use the
br
up (q) and down (w) buttons to
move the item selection cursor (0) to “Step
Edit”, and then press
br
ENTER.
• The “Step Edit” option will not be displayed if you
selected a variation type arpeggio in step 2 above.
OFF : The arpeggio will play while keyboard keys are
depressed.
ON : The arpeggio will continue to play even after the
keyboard keys are released
OFF : Sync setting is turned off.
ON : Arpeggio play is synced with only the play
operation of the Step Sequencer.
S/S : Arpeggio play is synced with both the play and
stop operations of the Step Sequencer.
Editing an Arpeggio
TYPE : Specifies the relative position in the arpeggio
pattern where each of the keyboard notes will play.
You can specify positions starting from the lowest
note played (L1) or from the highest note played
(U1). You can even specify simultaneous play of up
to five notes (P2 through P5).
NOTE : Specifies a relative shift, in semitone steps, from
the note played on the keyboard.
VELO : Specifies the volume of the note.
Step type
Step number