SMC Networks SMC TigerAccess SMC7824M/FSW - Manual (Page 381)

S
YSTEM
M
ODE
C
OMMANDS
19-11
Default Setting
No system mode is set; the switch functions in normal operating mode.
Command Mode
Global Configuration
Command Usage
Make sure that no dot1q-tunnel port is configured before exiting QinQ
mode (see “switchport mode dot1q-tunnel” on page 30-25). If there are
any dot1q-tunnel ports set on the switch, the no system mode
command will fail.
Example
Related Commands
show system mode (19-11)
show system mode
This command displays the switch system mode.
Command Mode
Privileged Exec
Command Usage
The system mode displays as QinQ or Normal mode.
Example
Related Commands
system mode (19-10)
Console(config)#system mode qinq
Console(config)#
Console(config)#system mode qinq
Console(config)#end
Console#show system mode
System mode is QinQ mode
Console#