SMC Networks SMC TigerAccess SMC7824M/FSW - Manual (Page 499)

IP S
OURCE
G
UARD
C
OMMANDS
22-5
the IP address of a neighbor to access the network. This section describes
commands used to configure IP Source Guard.
ip source-guard
This command configures the switch to filter inbound traffic based source
IP address, or source IP address and corresponding MAC address. Use the
no form to disable this function.
Syntax
ip source-guard {sip | sip-mac}
no ip source-guard
• sip - Filters traffic based on IP addresses stored in the binding table.
• sip-mac - Filters traffic based on IP addresses and corresponding
MAC addresses stored in the binding table.
Default Setting
Disabled
Command Mode
Interface Configuration (Ethernet)
Table 22-3 IP Source Guard Commands
Command Function Mode Page
ip source-guard Configures the switch to filter inbound traffic
based on source IP address, or source IP address
and corresponding MAC address
IC 22-5
ip source-guard
binding Adds a static address to the source-guard
binding table GC 22-7
show ip
source-guard Shows whether source guard is enabled or
disabled on each interface PE 22-9
show ip
source-guard
binding Shows the source guard binding table PE 22-9