SMC Networks SMC TigerAccess SMC7824M/FSW - Manual (Page 548)

I
NTERFACE
C
OMMANDS
24-8
To enable flow control under auto-negotiation, “flowcontrol” must
be included in the capabilities list for any port
• Avoid using flow control on a port connected to a hub unless it is
actually required to solve a problem. Otherwise back pressure
jamming signals may degrade overall performance for the segment
attached to the hub.
Example
The following example enables flow control on port 5.
Related Commands
negotiation (24-5)
capabilities (flowcontrol, symmetric) (24-6)
media-type
This command forces the port type selected for combination ports 27-28.
Use the no form to restore the default mode.
Syntax
media-type mode
no media-type
mode
• copper-forced - Always uses the built-in RJ-45 port.
• sfp-forced - Always uses the SFP port (even if module not
installed).
• sfp-preferred-auto - Uses SFP port if both combination types
are functioning and the SFP port has a valid link.
Default Setting
sfp-preferred-auto
Command Mode
Interface Configuration (Ethernet - Ports 27-28)
Console(config)#interface ethernet 1/5
Console(config-if)#flowcontrol
Console(config-if)#no negotiation
Console(config-if)#