SMC Networks SMC TigerAccess SMC7824M/FSW - Manual (Page 617)

30-1
C
HAPTER
30
VLAN C
OMMANDS
A VLAN is a group of ports that can be located anywhere in the network,
but communicate as though they belong to the same physical segment.
This section describes commands used to create VLAN groups, add port
members, specify how VLAN tagging is used, and enable automatic
VLAN registration for the selected interface.
Table 30-1 VLAN Commands
Command Groups Function Page
GVRP and
Bridge Extension Configures GVRP settings that permit automatic
VLAN learning; shows the configuration for
bridge extension MIB 30-2
Editing VLAN Groups Sets up VLAN groups, including name, VID and
state
30-7
Configuring VLAN
Interfaces Configures VLAN interface parameters,
including ingress and egress tagging mode,
ingress filtering, PVID, and GVRP 30-9
Displaying VLAN
Information Displays VLAN groups, status, port members,
and MAC addresses 30-16
Configuring Private
VLANs Configures private VLANs, including uplink and
downlink ports 30-17
Configuring Protocol
VLANs Configures protocol-based VLANs based on
frame type and protocol 30-19
Configuring 802.1Q
Tunneling Configures IEEE 802.1Q tunneling (QinQ) to
segregate and preserve customer VLAN IDs for
traffic crossing the service provider network 30-24