SMC Networks SMC TigerAccess SMC7824M/FSW - Manual (Page 695)

M
ULTICAST
VLAN R
EGISTRATION
C
OMMANDS
33-17
• IGMP snooping must be enabled to a allow a subscriber to
dynamically join or leave an MVR group (see ip igmp snooping on
page 33-2). Note that only IGMP version 2 or 3 hosts can issue
multicast join or leave messages.
Example
The following example enables MVR globally, and configures a range of
MVR group addresses:
mvr (Interface Configuration)
This command configures an interface as an MVR receiver or source port
using the type keyword, enables immediate leave capability using the
immediate keyword, or configures an interface as a static member of the
MVR VLAN using the group keyword. Use the no form to restore the
default settings.
Syntax
[no] mvr {type {receiver | source} | immediate | group ip-address}
• receiver - Configures the interface as a subscriber port that can
receive multicast data.
• source - Configure the interface as an uplink port that can send and
receive multicast data for the configured multicast groups.
• immediate - Configures the switch to immediately remove an
interface from a multicast stream as soon as it receives a leave
message for that group.
• ip-address - Statically configures an interface to receive multicast
traffic from the IP address specified for an MVR multicast group.
(Range: 224.0.1.0 - 239.255.255.255)
Default Setting
The port type is not defined.
Immediate leave is disabled.
No receiver port is a member of any configured multicast group.
Console(config)#mvr
Console(config)#mvr group 228.1.23.1 10
Console(config)#