SMC Networks SMC TigerAccess SMC7824M/FSW - Manual (Page 52)

B
ASIC
C
ONFIGURATION
2-6
4. Type “username admin password 0 password,” for the Privileged Exec
level, where password is your new password. Press <Enter>.
Setting an IP Address
You must establish IP address information for the switch to obtain
management access through the network. This can be done in either of the
following ways:
Manual — You have to input the information, including IP address and
subnet mask. If your management station is not in the same IP subnet as
the switch, you will also need to specify the default gateway router.
Dynamic — The switch sends IP configuration requests to BOOTP or
DHCP address allocation servers on the network.
Manual Configuration
You can manually assign an IP address to the switch. You may also need to
specify a default gateway that resides between this device and management
stations that exist on another network segment. Valid IP addresses consist
of four decimal numbers, 0 to 255, separated by periods. Anything outside
this format will not be accepted by the CLI program.
Note: An IP address for this switch is obtained via DHCP by default.
Username: admin
Password:
CLI session with the TigerAccess 10/100 is opened.
To end the CLI session, enter [Exit].
Console#configure 18-3
Console(config)#username guest password 0 [password] 21-2
Console(config)#username admin password 0 [password]
Console(config)#