SMC Networks SMC TigerAccess SMC7824M/FSW - Manual (Page 691)

S
TATIC
M
ULTICAST
R
OUTING
C
OMMANDS
33-13
Command Usage
The switch must use IGMPv2 or v3 snooping for this command to
take effect.
Example
The following shows how to configure the default timeout to 300 seconds:
Related Commands
ip igmp snooping version (33-4)
Static Multicast Routing Commands
This section describes commands used to configure static multicast
routing on the switch.
ip igmp snooping vlan mrouter
This command statically configures a multicast router port. Use the no
form to remove the configuration.
Syntax
[no] ip igmp snooping vlan vlan-id mrouter interface
• vlan-id - VLAN ID (Range: 1-4093)
• interface
• ethernet unit/port
- unit - Stack unit. (Range: 1)
- port - Port number. (Range: 1-28)
• port-channel channel-id (Range: 1-32)
Console(config)#ip igmp snooping router-port-expire-time 300
Console(config)#
Table 33-4 Static Multicast Routing Commands
Command Function Mode Page
ip igmp snooping vlan
mrouter Adds a multicast router port GC 33-13
show ip igmp snooping
mrouter Shows multicast router ports PE 33-14