Sun Microsystems SUN STOREDGETM 5310 NAS - Manual (Page 208)

3-8 Sun StorEdge 5310 NAS Troubleshooting Guide • December 2004
FIGURE 3-9 Tray ID Switch
3.1.2 Using the Array
This chapter provides general operating procedures for the array command module.
3.1.2.1 Removing and Replacing the Back Cover
Caution – Potential damage to cables. To prevent degraded performance or
damaged cables, do not bend or pinch the cables between the module and the
backfire.
Back covers are available only on deskside modules. If you have a rackmount
module, you must open the hinged door or remove the access panel of the
rackmount cabinet.Removing the back cover lets you see the indicator lights and
access the cables and module components.To remove and replace the back cover, use
the following procedure.
Figure 3-10 illustrates the procedure.