Sun Microsystems SUN STOREDGETM 5310 NAS - Manual (Page 355)

Chapter 7 FRU/CRU Replacement Procedures 7-19
7.6.10.2 Replacing the Flash Disk
Note – The Flash Disk must be replaced while the cover is removed from the
chassis.
Caution – Before touching or replacing any component inside the Sun StorEdge
5310 NAS, disconnect all external cables and follow the instructions in “Safety:
Before You Remove the Cover” on page 7-2 and “Removing and Replacing the
Cover” on page 7-2. Always place the server on a grounded ESD pad and wear a
properly grounded antistatic wrist strap.
To replace the Flash disk, follow these steps:
1. Before removing the cover to work inside the system, observe the previously
stated safety guidelines.
2. Remove the chassis cover.
3. Locate the Flash disk on the mother board, next to the ribbon cable and power
supply housing unit.
4. Disconnect the Flash disk cable from the housing.
5. Remove the Flash disk from its holder.
6. Install the new Flash disk.
7. Install the cable from the Flash disk and plug it into the connector.