Sun Microsystems SUN STOREDGETM 5310 NAS - Manual (Page 368)

7-32 Sun StorEdge 5310 NAS Troubleshooting Guide • December 2004
b. Remove the single screw securing the battery bracket, slide the bracket
sideways to clear the lugs, and lift the bracket up. Figure 7-18 show the bracket
in relation to the controller.
c. Disconnect the battery harness from its controller board connector.
d. Remove the battery from the controller.
You may need to hold the controller close above a flat surface and let the battery
fall out. Do not let the battery pull on the battery harness.
e. Connect the battery harness on the replacement battery to the connector on the
controller board in the new controller. Figure 7-18 illustrates this connection.
f. Position the battery inside the new controller.
g. Replace the controller cover and secure the screws. Figure 7-17 shows these
screws.
11. Update the following information on the new controller labels and attach the
labels to the replacement controller. Figure 7-19 shows the locations of the labels.
■ Date of Installation - Enter today's date.