Sun Microsystems SUN STOREDGETM 5310 NAS - Manual (Page 365)

Chapter 7 FRU/CRU Replacement Procedures 7-29
21. Is the problem corrected?
■
Yes - Go to step 22.
■
No - Contact technical support.
22. Remove the antistatic protection.
23. If needed, replace the back cover.
24. Use the Array Management Window to check the status of each module.
25. Do any components have a Needs Attention status?
■
Yes - Select the Recovery Guru toolbar button in the Array Management
Window and complete the recovery procedure. If the problem persists, contact
technical support.
■
No - Go to step 26.
26. Create, save, and print a new storage array profile.
End Of Procedure
FIGURE 7-14 Controller Host Link, Drive Link, and Fault Lights
7.7.2 Replacing a Controller Battery
Use the following procedure to replace a controller battery and command module or
command module.
7.7.2.1 Tools and Equipment
■ Antistatic protection
■ Phillips-head screwdriver
■
Replacement controller battery