3 preparing the system for diagnostic testing, 1 specific problems and corrective actions, Preparing the system for diagnostic testing 4 – Sun Microsystems SUN STOREDGETM 5310 NAS User Manual
Page 50: Table 2-1
2-4
Sun StorEdge 5310 NAS Troubleshooting Guide • December 2004
2.2.3
Preparing the System for Diagnostic Testing
Caution –
Turn off devices before disconnecting cables. Before disconnecting any
peripheral cables from the system, turn off the system and any external peripheral
devices. Failure to do so can cause permanent damage to the system and/or the
peripheral devices.
1. Turn off the system and all external peripheral devices. Disconnect all of them
from the system, except the keyboard and video monitor.
2. Make sure the system power cord is plugged into a properly grounded AC outlet.
3. Make sure your video display monitor and keyboard are correctly connected to
the system. Turn on the video monitor. Set its brightness and contrast controls to
at least two thirds of their maximum ranges (see the documentation supplied with
your video display monitor).
4. Turn on the system. If the power LED does not light, see “Power LED Does Not
5. If errors are encountered, power off the system, remove all add-in cards, and turn
the power back on.
2.2.3.1
Specific Problems and Corrective Actions
This section provides possible solutions for the specific problems listed in Table 2-1.
Try the solutions in the order given.
TABLE 2-1
Index to Problems
Problems
Reference