Sun Microsystems SUN STOREDGETM 5310 NAS - Manual (Page 238)

3-38 Sun StorEdge 5310 NAS Troubleshooting Guide • December 2004
FIGURE 3-20 Power Supply Switches
Note – IMPORTANT If you accidentally remove an active drive, wait at least 30
seconds and then reinstall it. For recovery procedures, refer to your storage
management software.
12. Lift the locking lever on the drive and remove it from the slot.
13. Slide the new drive all the way into the empty slot and close the drive lever.
14. Repeat step 12 and step 13 for each drive you are replacing.
FIGURE 3-21 Removing and Installing a Drive
15. After installing all of the new drives, turn on both power switches on the
command module.
As the drives spin up, the Fault lights may flash intermittently. If the Active light
begins to flash, data is being restored to the new drive.
16. Choose one of the following steps, based on the status of the Active and Fault
lights: