SMC Networks SMC Tiger 10/100 SMC6128L2 - Manual (Page 415)

A
CCESS
C
ONTROL
L
IST
C
OMMANDS
4-115
access-list ip
This command adds an IP access list and enters configuration mode for
standard or extended IP ACLs. Use the no form to remove the specified
ACL.
Syntax
[no] access-list ip {standard | extended} acl_name
• standard – Specifies an ACL that filters packets based on the
source IP address.
• extended – Specifies an ACL that filters packets based on the
source or destination IP address, and other more specific criteria.
• acl_name – Name of the ACL. (Maximum length: 16 characters)
Default Setting
None
Command Mode
Global Configuration
Command Usage
• An egress ACL must contain all deny rules.
• When you create a new ACL or enter configuration mode for an
existing ACL, use the permit or deny command to add new rules to
show ip access-list Displays the rules for configured IP
ACLs
PE 4-118
ip access-group Adds a port to an IP ACL IC 4-119
show ip
access-group Shows port assignments for IP ACLs PE 4-119
map access-list ip Sets the CoS value and corresponding
output queue for packets matching an
ACL rule IC 4-120
show map
access-list ip Shows CoS value mapped to an access
list for an interface PE 4-121
Table 4-34 IP ACL Commands (Continued)
Command Function Mode Page