SMC Networks SMC Tiger 10/100 SMC6128L2 - Manual (Page 417)

A
CCESS
C
ONTROL
L
IST
C
OMMANDS
4-117
uses 1 bits to indicate “match” and 0 bits to indicate “ignore.” The
bitmask is bitwise ANDed with the specified source IP address, and
then compared with the address for each IP packet entering the port(s)
to which this ACL has been assigned.
Example
This example configures one permit rule for the specific address 10.1.1.21
and another rule for the address range 168.92.16.x – 168.92.31.x using a
bitmask.
Related Commands
access-list ip (4-115)
permit, deny (Extended ACL)
This command adds a rule to an Extended IP ACL. The rule sets a
filter condition for packets with specific source or destination IP
addresses, protocol types, source or destination protocol ports, or TCP
control codes. Use the no form to remove a rule.
Syntax
[no] {permit | deny} [protocol-number | udp]
{any | source address-bitmask | host source}
{any | destination address-bitmask | host destination}
[source-port sport [end]] [destination-port dport [end]]
[no] {permit | deny} tcp
{any | source address-bitmask | host source}
{any | destination address-bitmask | host destination}
[source-port sport [end]] [destination-port dport [end]]
• protocol-number – A specific protocol number. (Range: 0-255)
• source – Source IP address.
• destination – Destination IP address.
• address-bitmask – Decimal number representing the address bits to
match.
• host – Keyword followed by a specific IP address.
Console(config-std-acl)#permit host 10.1.1.21
Console(config-std-acl)#permit 168.92.16.0 255.255.240.0
Console(config-std-acl)#