SMC Networks SMC Tiger 10/100 SMC6128L2 - Manual (Page 460)

C
OMMAND
L
INE
I
NTERFACE
4-160
Example
The following shows mirroring configured from port 6 to port 11.
Rate Limit Commands
This function allows the network manager to control the maximum rate
for traffic received on an interface. Rate limiting is configured on interfaces
at the edge of a network to limit traffic into the network. Packets that
exceed the acceptable amount of traffic are dropped.
Rate limiting can be applied to individual ports or trunks. When an
interface is configured with this feature, the traffic rate will be monitored
by the hardware to verify conformity. Non-conforming traffic is dropped,
conforming traffic is forwarded without any changes.
rate-limit
This command defines the rate limit for a specific interface. Use this
command without specifying a rate to restore the default rate. Use the no
form to restore the default status of disabled.
Syntax
rate-limit {input} [rate]
no rate-limit {input}
Console(config)#interface ethernet 1/11
Console(config-if)#port monitor ethernet 1/6
Console(config-if)#end
Console#show port monitor
Port Mirroring
-------------------------------------
Destination port(listen port):Eth1/1
Source port(monitored port) :Eth1/6
Mode :RX/TX
Console#
Table 4-46 Rate Limit Commands
Command Function Mode Page
rate-limit Configures the maximum input or output
rate for a port IC 4-160