SMC Networks SMC Tiger 10/100 SMC6128L2 - Manual (Page 91)

B
ASIC
C
ONFIGURATION
3-37
Web – Click System, Log, System Logs. Specify System Log Status, set the
level of event messages to be logged to RAM and flash memory, then click
Apply.
Figure 3-17. System Logs
CLI – Enable system logging and then specify the level of messages to be
logged to RAM and flash memory. Use the show logging command to
display the current settings.
Remote Log Configuration
The Remote Logs page allows you to configure the logging of messages
that are sent to syslog servers or other management stations. You can also
limit the error messages sent to only those messages below a specified
level.
Command Attributes
• Remote Log Status – Enables/disables the logging of debug or error
messages to the remote logging process. (Default: Enabled)
• Logging Facility – Sets the facility type for remote logging of syslog
messages. There are eight facility types specified by values of 16 to 23.
The facility type is used by the syslog server to dispatch log messages
Console(config)#logging on 4-57
Console(config)#logging history ram 0 4-58
Console(config)#end
Console#show logging flash
4-62
Syslog logging: Enabled
History logging in FLASH: level emergencies
Console#