SMC Networks SMC Tiger 10/100 SMC6128L2 - Manual (Page 579)

S
WITCH
C
LUSTER
C
OMMANDS
4-279
cluster
This command enables clustering on the switch. Use the no form to
disable clustering.
Syntax
[no] cluster
Default Setting
Enabled
Command Mode
Global Configuration
Command Usage
• To create a switch cluster, first be sure that clustering is enabled on the
switch (the default is enabled), then set the switch as a Cluster
Commander. Set a Cluster IP Pool that does not conflict with any
other IP subnets in the network. Cluster IP addresses are assigned to
switches when they become Members and are used for
communication between Member switches and the Commander.
Table 4-77 Switch Cluster Commands
Command Function Mode Page
cluster Configures clustering on the switch GC 4-270
cluster
commander Configures the switch as a cluster
Commander GC 4-272
cluster ip-pool Sets the cluster IP address pool for
Members GC 4-273
cluster member Sets Candidate switches as cluster members GC 4-274
rcommand Provides configuration access to Member
switches GC 4-275
show cluster Displays the switch clustering status PE 4-276
show cluster
members Displays current cluster Members PE 4-277
show cluster
candidates Displays current cluster Candidates in the
network PE 4-277