SMC Networks SMC Tiger 10/100 SMC6128L2 - Manual (Page 503)

VLAN C
OMMANDS
4-203
switchport native vlan
This command configures the PVID (i.e., default VLAN ID) for a port.
Use the no form to restore the default.
Syntax
switchport native vlan vlan-id
no switchport native vlan
vlan-id - Default VLAN ID for a port.
(Range: 1-4093, no leading zeroes)
Default Setting
VLAN 1
Command Mode
Interface Configuration (Ethernet, Port Channel)
Command Usage
• Setting the native VLAN for a port can only be performed when the
port is a member of the VLAN and the VLAN is untagged. The “no
switchport native vlan” command will set the native VLAN of the
port to untagged VLAN 1.
• If acceptable frame types is set to all or switchport mode is set to
hybrid, the PVID will be inserted into all untagged frames entering
the ingress port.
Example
The following example shows how to set the PVID for port 1 to VLAN 3:
Console(config)#interface ethernet 1/1
Console(config-if)#switchport native vlan 3
Console(config-if)#