SMC Networks SMC Tiger 10/100 SMC6128L2 - Manual (Page 95)

B
ASIC
C
ONFIGURATION
3-41
CLI – Enter the host ip address, followed by the mail severity level, source
and destination email addresses and enter the sendmail command to
complete the action. Use the show logging command to display SMTP
information.
Resetting the System
Web – Click System, Reset. Click the Reset button to reboot the switch.
When prompted, confirm that you want reset the switch.
Figure 3-20. Resetting the System
CLI – Use the reload command to restart the switch. When prompted,
confirm that you want to reset the switch.
Note: When restarting the system, it will always run the Power-On
Self-Test.
Console(config)#logging sendmail host 192.168.1.19
Console(config)#logging sendmail level 3
Console(config)#logging sendmail source-email
[email protected]
Console(config)#logging sendmail destination-email
[email protected]
Console(config)#logging sendmail
Console#
Console#reload 4-30
System will be restarted, continue <y/n>?