SMC Networks SMC Tiger 10/100 SMC6128L2 - Manual (Page 499)

VLAN C
OMMANDS
4-199
interface vlan
This command enters interface configuration mode for VLANs, which is
used to configure VLAN parameters for a physical interface.
Syntax
interface vlan vlan-id
vlan-id - ID of the configured VLAN. (Range: 1-4093, no leading
zeroes)
Default Setting
None
Command Mode
Global Configuration
Example
The following example shows how to set the interface configuration mode
to VLAN 1, and then assign an IP address to the VLAN:
Related Commands
shutdown (4 -149)
switchport native vlan Configures the PVID (native VLAN) of
an interface
IC 4-203
switchport allowed
vlan Configures the VLANs associated with
an interface IC 4-204
switchport gvrp Enables GVRP for an interface IC 4-216
switchport forbidden
vlan Configures forbidden VLANs for an
interface IC 4-205
switchport priority
default Sets a port priority for incoming
untagged frames IC 4-220
Console(config)#interface vlan 1
Console(config-if)#ip address 192.168.1.254 255.255.255.0
Console(config-if)#
Table 4-56 Configuring VLAN Interfaces
Command Function Mode Page