Print too dark, Print too light, Printing slow – Kodak ESP 9 User Manual
Page 108: Printing stops
Troubleshooting
100
www.kodak.com/go/aiosupport
Print too dark
• Try retaking the picture with the flash on, or move within the flash range of the
camera. Refer to your camera user’s guide for details.
• Adjust the exposure compensation on your camera and try taking the picture
again. Refer to your camera user’s guide for details.
• Edit the picture using Kodak Home Center (Windows only) or other image
editing software.
• Make sure the printer is not placed in direct sunlight or is not operating in a
high-temperature environment.
Print too light
CAUTION:
For best results, use Kodak paper and ink cartridges for your Kodak
All-in-One printer.
• Make sure the paper is loaded with the print side face down. Reload it if
necessary.
• Try taking the picture again with the flash off. Refer to your camera user’s guide
for details.
• Adjust the exposure compensation on your camera and try taking the picture
again. Refer to your camera user’s guide for details.
• Edit the picture on your computer.
Printing slow
NOTE: When printing a large number of prints, printing may slow down to prevent
the printhead from overheating.
• Make sure the printer is not placed in direct sunlight or is not operating in a
high-temperature environment (higher than 95° Fahrenheit or 35° Celsius).
• Close any unnecessary software applications.
• Make sure your computer meets the minimum system requirements. Upgrade
your system if necessary.
Printing stops
Printing stops during mid-print. Paper stops feeding, and status light may blink.
CAUTION:
For best results, use Kodak paper and ink cartridges for your Kodak
All-in-One printer.