Kodak ESP 9 - Manual (Page 84)

76 www.kodak.com/go/aiosupport
9
Maintaining Your Printer
Your Kodak ESP 9 All-in-One printer requires little maintenance. However, Kodak
recommends cleaning the scanner glass and lid backing regularly to remove dust
and fingerprints. Fingerprints and other debris on the glass or lid backing could slow
down the printer’s performance, and affect the quality and accuracy of scanning.
Service agreements are available in some countries. Contact dealers for Kodak
products for more information.
For recycling and/or disposal information, contact your local authorities. In the U.S.,
visit the Electronics Industry Alliance Web site at
www.eiae.org.
General care
CAUTION:
Always disconnect the power on the this All-in-One printer before cleaning it.
Do not use harsh or abrasive cleaners or organic solvents on the printer or
any of its parts.
• To clean the printer, wipe the outside with a clean, dry cloth.
• Keep the surrounding area vacuumed and litter-free.
• Protect the printer from tobacco smoke, dust, sand, other small particles (such
as crumbs), and liquid spills.
• Avoid placing objects on the printer.
• Keep the printer supplies away from direct sunlight and out of high-temperature
environments.
• Do not allow chemicals, such as suntan lotion, to come into contact with the
painted surface of the printer.
• If the printer has been exposed to bad weather or has water inside it, turn it off
and let it dry completely. If this does not solve the problem, contact customer
support (see
Contacting Kodak Customer Service & Support, page 2 ).
Cleaning the scanner glass
For good copies and scans, ensure the printer's scanner glass and lid backing are
clean; dust the exterior as needed.
WARNING: Do not use abrasives, acetone, benzene, or carbon tetrachloride
on the glass, as they can damage it. Do not place or spray liquid directly on the
glass. The liquid might seep under the glass and damage the device.